How To Weave A Box

Look what I've been doing this week.  I've been learning how to weave a box with clear instructions.  If you
want to make one ill tell you.  First you will need some equipment.

Equipment
Scissors
Ruler
Paper
Sellotape
Pen/Pencil

Once you have gathered all your equipment your ready to start.

Instructions 

1.  Measure ten strips of paper 1 cm wide and 30 cm long.
2.  Then you cut your ten pieces of paper out.
3.  After that you place five strips on the ground/mat next to each other,about  2 cm width apart.
4. Then grab one of the strips that are not on the ground/mat and weave it through the ones on the ground/mat buy going under the first one and over the next one until you get to the end.
5.  Repeat step 4 using the 4 strips remaining.
6.  Once you have completed step 5 you careful push the strips in to the middle so their touching each other and make the inside makes a square.
7.  Sellotape each corner to help keep the strips in place.
8.  To make the sides of the box,fold the outside strips back to the base ( To keep the out sides straight fold the strips using the line of you base as your guyed.
9.  Cut out 4 strips that are 24 cm long and 1 cm wide.
10.  Take one strip and fold it into 4 quarters ( to give it 4 corners )
11.  With the same strip weave it through the 4 sides ( keep it tight )
12.  Sellotape each comer to keep the strip in place.
13.  Repeat steps 12 and 13 with the 3 remaining strips.
14.  To finish the box make sure you fold over any strips sticking up and tape them down

Hopefully you manged to make the box with my instructions.